Medium wave (MW) is the part of the medium frequency (MF) radio band used mainly for AM radio broadcasting. For Europe the MW band ranges from 526.5 kHz to 1606.5 kHz1 and in North America an extended MW broadcast band goes from 535 kHz to 1705 kHz.2
Medium wave signals have the property of following the curvature of the earth (the groundwave) at all times, and also refracting off the ionosphere at night (skywave). This makes this frequency band ideal for both local and continent-wide service, depending on the time of day. For example, during the day a radio receiver in the state of Colorado is able to receive reliable but weak signals from high-power stations such as 770 KKOB, or 610 KNML 500 miles away from their towers in Albuquerque, New Mexico, due to groundwave propagation. The effectiveness of groundwave signals largely depends on ground conductivity and higher conductivity results in better propagation. At night, the same receiver may pick up signals as far away as 1110 KFAB in Nebraska reliably, depending on atmospheric noise and man-made interference.
Initially broadcasting in the United States was restricted to two wavelengths: "entertainment" was broadcast at 360 meters (833 kHz), with stations required to switch to 485 meters (619 kHz) when broadcasting weather forecasts, crop price reports and other government reports.4 This arrangement had numerous practical difficulties. Early transmitters were technically crude and virtually impossible to set accurately on their intended frequency and if (as frequently happened) two (or more) stations in the same part of the country broadcast simultaneously the resultant interference meant that usually neither could be heard clearly. The Commerce Department rarely intervened in such cases but left it up to stations to enter into voluntary timesharing agreements amongst themselves. The addition of a third "entertainment" wavelength, 400 meters,4 did little to solve this overcrowding.
In 1923, the Commerce Department realized that as more and more stations were applying for commercial licenses, it was not practical to have every station broadcast on the same three wavelengths. On May 15, 1923, Commerce Secretary Herbert Hoover announced a new bandplan which set aside 81 frequencies, in 10 kHz steps, from 550 kHz to 1350 kHz (extended to 1500, then 1600 and ultimately 1700 kHz in later years). Each station would be assigned one frequency (albeit usually shared with stations in other parts of the country and/or abroad), no longer having to broadcast weather and government reports on a different frequency than entertainment. Class A and B stations were segregated into sub-bands.5
Nowadays in most of the Americas, mediumwave broadcast stations are separated by 10 kHz and have two sidebands of up to ± 5 kHz in theory, although in practice stations transmit audio of up to 10 kHz.6 In the rest of the world, the separation is 9 kHz, with sidebands of ± 4.5 kHz. Both provide adequate audio quality for voice, but are insufficient for high-fidelity broadcasting, which is common on the VHF FM bands. In the US and Canada the maximum transmitter power is restricted to 50 kilowatts, while in Europe there are medium wave stations with transmitter power up to 2 megawatts daytime.citation needed
Most United States AM radio stations are required by the Federal Communications Commission (FCC) to shut down, reduce power or employ a directional antenna array at night in order to avoid interference with each other due to night-time only long-distance skywave propagation ("skip"). Those stations which shut down completely at night are often known as "daytimers". Similar regulations are in force for Canadian stations, administered by Industry Canada; however, no daytimers exist in Canada, the last one having signed off in 2013.
In Europe, each country is allocated a number of frequencies on which high power (up to 2 MW) can be used; the maximum power is also subject to international agreement by the International Telecommunication Union ITU .7 In most cases there are two power limits: a lower one for omnidirectional and a higher one for directional radiation with minima in certain directions. The power limit can also be depending on daytime and it is possible, that a station may not work at nighttime, because it would then produce too much interference. Other countries may only operate low-powered transmitters on the same frequency, again subject to agreement. For example, Russia operates a high-powered transmitter, located in its Kaliningrad exclave and used for external broadcasting, on 1386 kHz. The same frequency is also used by low-powered local radio stations in the United Kingdom, which has approximately 250 medium-wave transmitters of 1 kW and over;8 other parts of the United Kingdom can still receive the Russian broadcast. International mediumwave broadcasting in Europe has decreased markedly with the end of the Cold War and the increased availability of satellite and Internet TV and radio, although the cross-border reception of neighbouring countries' broadcasts by expatriates and other interested listeners still takes place.
Due to the high demand for frequencies in Europe, many countries operate single frequency networks; in Britain, BBC Radio Five Live broadcasts from various transmitters on either 693 or 909 kHz. These transmitters are carefully synchronized to minimize interference from more distant transmitters on the same frequency.
Overcrowding on the Medium wave band is a serious problem in parts of Europe contributing to the early adoption of VHF FM broadcasting by many stations (particularly in Germany). However in recent years several European countries (Including Ireland, Poland and, to a lesser extent Switzerland) have started moving away from Medium wave altogether with most/all services moving exclusively to other bands (usually VHF).
Stereo transmission is possible and offered by some stations in the U.S., Canada, Mexico, the Dominican Republic, Paraguay, Australia, The Philippines, Japan, South Korea, South Africa, and France. However, there are multiple standards for AM stereo with C-QUAM being the most common in the United States as well as other countries, and receivers that implement the technologies are relatively rare.
In September 2002, the United States Federal Communications Commission approved the proprietary iBiquity in-band on-channel (IBOC) HD Radio system of digital audio broadcasting, which is meant to improve the audio quality of signals. The Digital Radio Mondiale (DRM) IBOC system has been approved by the ITU for use outside North America and U.S. territories.
For transmission, vertical radiators (masts) are most commonly used. Stations broadcasting with low power can use masts with heights of a quarter-wavelength (about 310 millivolts per meter using one kilowatt at one kilometer) to 5/8 wavelength (225 electrical degrees; about 440 millivolts per meter using one kilowatt at one kilometer), while high power stations mostly use half-wavelength to 5/9 wavelength. The usage of masts taller than 5/9 wavelength (200 electrical degrees; about 410 millivolts per meter using one kilowatt at one kilometer) with high power gives a poor vertical radiation pattern, and 195 electrical degrees (about 400 millivolts per meter using one kilowatt at one kilometer) is generally considered ideal in these cases. Usually mast antennas are series-excited (i.e., are insulated from the ground). Shunt-excited masts (i.e., not insulated from the ground, hence "grounded at the base") have fallen into disuse, except in cases of exceptionally high power, 1 MW or more, where series excitement might be impractical.
If grounded masts or towers are required, then cage aerials or long-wire aerials are used. Another possibility consists of feeding the mast or the tower by cables running from the tuning unit to the guys or crossbars in a certain height. Directional aerials consist of multiple masts, which need not to be from the same height. It is also possible to realize directional aerials for mediumwave with cage aerials where some parts of the cage are fed with a certain phase difference.
For medium-wave (AM) broadcasting, quarter-wave masts are between 153 feet (47 m) and 463 feet (141 m) high, depending on the frequency. Because quarter-wave masts are so large they can be unnecessarily costly and uneconomic, and other types are more commonly used on medium wave for local broadcast stations of under 5 kW, examples being T- and L-antennas. The design of these smaller antennas uses the technique commonly used on Long Wave to allow smaller masts to be used.9 In this method the mast size is reduced, producing less radiation resistance and increased reactance, and wires are added, supported by the same mast or masts, to compensate these deficiencies adequately. The details depend on the requirement for grounded or insulated towers and masts. The dimensions can and must be calculated accurately to meet the required specifications in bandwidth, power handling and radiation efficiency.
A popular choice for lower-powered stations is the umbrella antenna, which needs only one mast one tenth wavelength or less in height. This antenna uses a single mast insulated from ground and fed at the lower end against ground. In that sense it is a simple monopole, but at the top of the mast extra wires are connected (usually about six) which slope downwards at an angle of 40-45 degrees as far as about one-third of the total height, where they are terminated in insulators and thence outwards to ground anchors. Thus the umbrella antenna can use the guy wires as part of the antenna.
In some rare cases dipole antennas are used, which are slung between two masts or towers. Such antennas are intended to radiate a skywave. The medium-wave transmitter at Berlin-Britz for transmitting RIAS used a cross dipole mounted on five 30.5 metre high guyed masts to transmit the skywave to the ionosphere at nighttime.
Europe's largest antenna park 10 is placed in Northern Jutland, Denmark. The well-known German DX'er Wilhelm Herbst has constructed and built the antennas. DXers are welcome to use the facilities.
For low-noise reception at frequencies below 1.6 MHz, which includes long and medium waves, loop antennas are popular because of their ability to reject locally generated noise. This class of antennas includes the ferrite-rod antenna, also known as a loopstick antenna, which is by far the most common antenna in use for broadcast reception throughout the world. Transistor radios contain a loopstick as the receiving antenna.
- Medium frequency band, of which the medium wave band forms a part.
- AM radio
- MW DX
- FM radio
- Satellite radio
- List of European medium wave transmitters
- Wave plan of Geneva
- "United Kingdom Frequency Allocation Table 2008". Ofcom. p. 21. Retrieved 2010-01-26.
- "U.S. Frequency Allocation Chart". National Telecommunications and Information Administration, U.S. Department of Commerce. October 2003. Retrieved 2009-08-11.
- "Digital Medium Wave - your questions answered". BBC Devon. BBC. Retrieved 2009-04-24.
- "Building the Broadcast Band". Earlyradiohistory.us. Retrieved 2010-05-07.
- Christopher H. Sterling; John M. Kittross (2002). Stay tuned: a history of American broadcasting. Psychology Press. p. 95. ISBN 0-8058-2624-6.
- "Subpart A: AM Broadcast Stations, Sec. 73.44 AM transmission system emission limitations". TITLE 47--TELECOMMUNICATION, CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION (CONTINUED), PART 73_RADIO BROADCAST SERVICES. U.S. Government Printing Office. Revised as of October 1, 2006. Retrieved 2009-04-24.
- "International Telecommunication Union". ITU. Retrieved 2009-04-24.
- List of medium-wave transmitters in the UK
- Weeks, W.L 1968, Antenna Engineering, McGraw Hill Book Company, Section 2.6
- "Ydun's Medium Wave Info - Reports". Retrieved 2009-04-24. "DX 183 - EUROPE'S LARGEST ANTENNA PARK"
- "Building the Broadcast Band" the development of the 520-1700 kHz MW (AM) band
- M3 Map of Effective Ground Conductivity in the USA
- MWLIST worldwide database of MW and LW stations
- www.mwcircle.org The Mediumwave Circle. A UK-based club for Mediumwave DX'ers and enthusiasts.
-  - List of long- and mediumwave transmitters with GoogleMap-Links to transmission sites